Editing Eye-Fi Card Setup (section)

== Eye-Fi Setup ==

Eye-Fi, even when it's working, is super-slow. Importing about 15 shots takes well over 10 minutes. Switch to tethered import with a long USB cable. The maximum length for USB cables is 15'.

* Put the SD card in the receiver and plug them both into the laptop’s USB.
* Start the “Eye-Fi Center” software.
* File > Settings > Eye-Fi Card
* “Networks” tab
** Private Networks tab > select the appropriate router. It will try to connect and give a message indicating whether it was successful or not.
* “Raw” tab > Select destination folder for photos.
* '''Note:''' It seems like they have frequent firmware updates for the cards. The settings, esp “network”, don’t take unless the firmware gets installed. Keep an eye out when starting up.
* Close the Settings dialog.
* Eject the Eye-Fi card using the eject icon, and remove the Eye-Fi card from the receiver.
* With the camera powered off, insert it in the DSLR’s SD slot.
* Now when you shoot you should see the images should (slowly) import into the Eye-Fi center on the laptop.